Diamond Tool, 3 mil [Model 139-55]
Replacement conical diamond scratch tool used for scratching materials of ordinary hardness. This to..

Diamond Tool, 3.5 mil [Model 139-56]
Replacement conical diamond scratch tool used for scratching materials of ordinary hardness. This to..

Diamond Tool, 0.3 mm [Model 139-52]
Conical diamond scratch tool. This tool is precision lapped to a 60° angle, and includes a radius po..

Diamond Tool, 200 µm
Conical diamond scratch tool. This tool is precision lapped to a 120° angle, and includes a radius p..

Diamond Scratch Tool [Model 139-58]
Used for scratch testing unusually hard materials. The cutting edge of this tool is the converging p..

Scratch Tip, 0.25 mm
Tungsten carbide scratch tip with 60°, 0.25mm diameter point.  For use with Shear/Scratch Teste..

Scratch Tip, 0.25 mm per EN 14565
Tungsten carbide scratch tip with 45°, 0.25mm diameter point.  For use with Shear/Scratch Teste..

Scratch Tip, 1.0 mm (non-threaded)
1.0mm hemispherical tungsten carbide stylus for use with Shear/Scratch Testers model 550 or 551. Req..

Contour Shear Tool, S-20
The precision ground, Tungsten Carbide Contour Shear tool (S-20) is designed to shear a groove betwe..

Carbide Tool, S-20-3
Precision ground Tungsten Carbide tool to satisfy Honda requirements, has a cutting edge (R0). ..

Carbide Tool, S-20-4
Precision ground tungsten carbide tool with R2.6mm cutting edge. Used to evaluate scrape resistance ..

Scale Beam Calibration Verification Fixture, Shear/Scratch Tester
Use to verify the scale beam load applied to the scratch tool. ..

Diamond Tool Standardization Plates (2 each)
Poly Methyl Methacrylate plates are used to standardize the Model 139-56 Conical Diamond Tool (p/n 1..

Scale Beam Height Extension Kit
Increase the range of sample thicknesses that can be tested to 40mm. Includes scale beam adaptor, st..

Scale Beam Height Extension Kit
Increase the range of sample thicknesses that can be tested to 40mm. Includes scale beam adaptor, st..